Hobbywing SR2 Extended Sensor Cable 150mm

The Hobbywing SR2 Extended Sensor Cable (150mm) (Part No: HW30850308) is the compact version of Hobbywing’s waterproof sensor interface. This 150mm (approx. 6-inch) cable is designed for 1/10 and 1/8 scale builds where the standard factory cable is just a bit too short, or where you want to minimize "wire clutter" in a tight chassis without the excess slack of the 300mm version.

Key Features:

• Waterproof SR2 Interface: Utilizes the proprietary, keyed, and sealed "SR2" (Sensored-Waterproof) connectors to maintain an IP67 rating for your power system.
• Optimized for Compact Builds: The 150mm length is ideal for 1/10 scale trucks (like the MAX10 G2 setups) or 1/8 scale buggies where the ESC and motor are positioned relatively close together.
• Interference Shielding: High-quality internal conductors ensure low-latency communication between the motor and ESC, preventing throttle "cogging" and ensuring precise timing.
• Flexible & Durable: The soft-touch black insulation is designed to withstand high-vibration environments and tight bends without cracking or fatiguing.
• Secure Keyed Connection: The connectors are designed to only fit in one direction, protecting the sensitive sensor pins from being bent during installation.

Technical Specifications:

Pro-Tip:

If you are moving from an older non-waterproof setup (with the 6-pin flat JST connector) to a new G2/G3 waterproof setup, remember that this cable only connects SR2 ports to SR2 ports. If you need to mix an older motor with a new G2 ESC, you specifically need the Sensor Converter Cable (Part No: HW30810004), which features an SR2 connector on one end and a standard JST connector on the other.